Introduction to the correct installation method of glass doors
Whether the glass door is beautiful or not has a certain relationship with the installation method. Let me introduce the installation method of the glass door.
1. Positioning and setting-up
The glass doors are combined by fixed glass and movable glass doors, and the positioning of the line is unified. According to the requirements of the design and construction drawings, the positioning line of the glass door is released, and the position of the door frame is determined at the same time.
2. Limit slot at the top of the mounting frame
The width of the limit groove should be two to four millimeters greater than the thickness of the glass, and the depth of the groove should be ten to twenty millimeters. During installation, at the beginning, two metal decorative board edges are drawn from the center line of the bomb, and then the limit groove on the top of the door frame is installed according to the edge line, and the groove depth in the notch is adjusted through the glued backing plate.
3. Install the wooden bottom bracket with metal finish
Fix the square wood on the ground, and glue the metal veneer to the wood with all-purpose glue. If the aluminum alloy square tube is used, it can be fixed on the frame column with aluminum angles, or fixed on the wooden bricks buried in the ground with wood screws.
4. Install the vertical door frame
Connect the center line of the bullet and nail the door frame side.
1. Positioning and setting-up
The glass doors are combined by fixed glass and movable glass doors, and the positioning of the line is unified. According to the requirements of the design and construction drawings, the positioning line of the glass door is released, and the position of the door frame is determined at the same time.
2. Limit slot at the top of the mounting frame
The width of the limit groove should be two to four millimeters greater than the thickness of the glass, and the depth of the groove should be ten to twenty millimeters. During installation, at the beginning, two metal decorative board edges are drawn from the center line of the bomb, and then the limit groove on the top of the door frame is installed according to the edge line, and the groove depth in the notch is adjusted through the glued backing plate.
3. Install the wooden bottom bracket with metal finish
Fix the square wood on the ground, and glue the metal veneer to the wood with all-purpose glue. If the aluminum alloy square tube is used, it can be fixed on the frame column with aluminum angles, or fixed on the wooden bricks buried in the ground with wood screws.
4. Install the vertical door frame
Connect the center line of the bullet and nail the door frame side.
